Header question!

[Bluemach1]

Hey Craig!
Can you please tell me what you did for your headers? I am going to be faced with the same CA inspection that you had to go through.

Thanks!

Ted

[craighardy]

I used the factory manifolds. I had Renegade resurface them at a slight angle so that they hugged the block a bit tighter. They also cut down the passenger outlet flange and redrilled/tapped it for a standard 3 bolt exhaust flange. Lastly, you will need to send them the stearing shaft that runs from the firewall to the rack. They will add a universal joint so that it will clear the manifold. You can see some pictures of my exhaust manifolds in my gallery.

Craig

[Bluemach1]

Thanks! That is just what I was hoping. I can machine the stock manny's at work and I believe that I can get the parts fo the steering through Flaming River!

I wish I know what angle that they used....

I did check out yuour gallery. Now I can see that they are stock. Would you happen to have any other pictures for those of use that will need to go this route? Maybe some of them uninstalled?

[craighardy]

Sorry, those are the only pictures I have.